How to install and connect the laser to a WanhaoDuplicatori3 printer

1. You will need a screwdriver Т-8 or a hex key, 2 additional wires 1 meter 70 cm in length and a terminal block PA12-3A-4 mm U-Type.
   
   
2. Connect the laser wires to one side of the contact terminal and the additional ones – to the other side of the terminal.
   
3. Disconnect the fan and mount the laser.
   
   
4. Undo the upper part of the control block box.
   
5. Pull out the Fan cable connector.
   
6. Disconnect the fan cables off the Fan cable connector, connect the additional wires to the connector and fit the connector into the slot.
7. Put back the upper part of the control block box and fasten it.