Description
CO2 laser power supply Standard – a line of standard universal power supplies for most laser cutting and engraving machines. The sources meet all the requirements in the use of CO2 laser tubes, produced in large quantities by various manufacturers.
main characteristics:
– good compatibility,
– simple TTL level control: it has TTL signal indication, water indication and laser output signal.
– the block has protection against a chain break. It has a button to check the output laser manually.
– fast response speed, high efficiency.
| Model | Standard 50W |
| Rated power of laser tube, W | 50 |
| Input voltage | 220 / 110 V set by switch |
| AC supply frequency | 47-440 Hz | Maximum input current | 3A |
| Maximum input power< /td> | 440W |
| Leakage current | ≤0.7mA (AC220V) ≤0.4mA (AC110V) |
| Maximum output voltage | DC 22 kV |
| Maximum output current | DC 22 mA |
| Efficiency | 90% full load |
| Responsiveness/performance | ≤1ms (time from TTL signal is given for output current up to 90% preset current) |
| Protection | momentary disconnection (when there is a good ground) |
| Voltage withstand | AC1500V 10mA 60 seconds (cathode output connected to case) |
| Cooling | forced, air (built-in fan) |
| Operating temperature, deg | -10 ℃～ +40 ℃ |
| Relative humidity | up to 90% (non-condensing) |
| Time Between Failures (MTBF) | at least 10000 hours |
| Dimensions LxWxH | 188 * 145 * 90mm |
Reviews
There are no reviews yet.