Description
CO2 laser power supply Standard – a line of standard universal power supplies for most laser cutting and engraving machines. The sources meet all the requirements in the use of CO2 laser tubes, produced in large quantities by various manufacturers.
main characteristics:
– good compatibility,
– simple TTL level control: it has TTL signal indication, water indication and laser output signal.
– the block has protection against a chain break. Has a button to check the output laser manually.
– fast response speed, high efficiency.
– built-in digital display
< /br>
| Model | Standard 100W |
| Laser Tube Power | 100W |
| Input voltage | AC 220V or AC 110V |
| AC supply frequency | 47-440 Hz |
| Maximum output voltage | DC 28 kV |
| Maximum output current | DC 30 mA |
| Block dimensions | 230*161*91mm |
| Weight | 2.8 kg |
| Full Load Efficiency | 0.91 |
| Overcurrent protection | 130% of maximum current |
| Open circuit protection | momentary shutdown (when there is a good ground) |
| Cooling | forced, air (built-in fan) |
| High control voltage range | ≥3V |
| Low level control voltage range | ≤0.8V |
| Operating temperature | -30～ +65℃ |
| Relative Humidity | 20 ～85% non-condensing |
| Voltage resistance | AC1500V 1min. ≤10mA (cathode output connected to case) |
| Insulation resistance | ≥50MΩ at DC500V |
| Leakage current | ≤1mA at AC220V ≤0.5mA at AC110V |
| Vibration resistance | 2h 3D direction with amplitude 0.5mm frequency 10~55Hz |
| Mean Time Between Failures (MTBF) | ≥30000hrs |
| High Temperature Test Time | 12 hours 60ºC at full load |
| Testing | 7s on/off 500 times< /td> |
Reviews
There are no reviews yet.